Table of Contents
Advertisement
Adjusting the sound
The sound adjustments made as below will have an effect on the projector speaker. Be sure
you have made a correct connection to the projector audio input. See
17
for how the audio input is connected.
Muting the sound
To temporarily turn off the sound:
1.
Press MENU/EXIT and then press
is highlighted.
2.
Press
page displays.
3.
Highlight Mute and press
Adjusting the sound level
To adjust the sound level, press VOLUME+/VOLUME- or
1.
Repeat steps 1-2 above.
2.
Press
Turning off the Power On/Off Ring Tone
To turn off the ring tone:
1.
Repeat steps 1-2 above.
2.
Press
The only way to change Power On/Off Ring Tone is setting On or Off here. Setting the sound
mute or changing the sound level will not affect the Power On/Off Ring Tone.
Controlling the projector through a LAN
environment
You can manage and control the projector from a remote computer when they are properly
connected to the same local area network.
Cable connection
If you are in a DHCP environment:
1.
Take a RJ45 cable and connect one end to the RJ45 LAN input jack of the projector
and the other end to the RJ45 port on your Ethernet or router.
to highlight Audio Settings and press MODE/ENTER. The Audio Settings
/
to highlight Volume and press
to highlight Power On/Off Ring Tone and press
/
until the SYSTEM SETUP: Advanced menu
to select On.
/
to select a desired sound level.
"Connection" on page
/
, or:
/
to select Off.
Operation
35
Advertisement
Table of Contents
