Table of Contents
Advertisement
If you are in a non-DHCP environment:
1.
Repeat steps 1-4 above.
2.
Press
3.
Contact your ITS administrator for information on the Projector IP Address, Subnet
Mask, Default Gateway, and DNS Server settings.
4.
Press
5.
Press
6.
To save the settings, press MODE/ENTER. If you do not want to save the settings,
press MENU/EXIT.
7.
Press
Controlling the projector remotely through a web browser
Once you have the correct IP address for the projector and the projector is on or in standby
mode, you can use any computer that is on the same local area network to control the
projector.
1.
Enter the address of the projector in the address bar of your browser and click GO.
2.
The remote network operation page opens. This page allows you to operate the
projector as if you were using the remote control or control panel on the projector.
i. These buttons function the same as the ones on the OSD menus or remote
control. See
details.
The Menu button can also be used to go back to previous OSD menu, exit and save menu
settings.
ii. To switch input signal, click on your desired signal.
The source list varies according to the connectors available on the projector. "DVI-D 1" stands
for the DVI-D signal; "Video 1" stands for the Video signal; "S-Video 1" stands for the S-Video
signal.
42
Operation
to highlight DHCP and press
to select the item you want to modify and press MODE/ENTER.
/
to move the cursor and the press
to highlight Apply and press MODE/ENTER.
i
"2. PICTURE menu" on page 49
/
to select Off.
/
to enter the value.
ii
and
"Remote control" on page 11
i
i
for
Advertisement
Table of Contents
