Table of Contents
Advertisement
2.
Press MENU/EXIT and then press
is highlighted. Press
Network Settings page is displayed.
3.
Highlight Wired LAN and press MODE/ENTER.
4.
Make sure the Status is Connect.
5.
Press
to highlight DHCP and press
6.
Press
to highlight Apply and press MODE/ENTER.
7.
Re-enter the Network Settings page. The IP Address, Subnet Mask, Default Gateway,
DNS and Mac Address settings will be displayed. Note down the IP address displayed
in the IP Address row.
If the IP Address still does not appear, contact your ITS administrator.
If you are in a non-DHCP environment:
1.
Repeat steps 1-4 above.
2.
Press
to highlight DHCP and press
3.
Contact your ITS administrator for information on the IP Address, Subnet Mask,
Default Gateway, and DNS settings.
4.
Press
to select the item you want to modify and press MODE/ENTER.
5.
Press
/
6.
To save the settings, press MODE/ENTER. If you do not want to save the settings,
press MENU/EXIT.
7.
Press
to highlight Apply and press MODE/ENTER.
Controlling the projector remotely through a web browser
Once you have the correct IP address for the projector and the projector is on or in standby
mode, you can use any computer that is on the same local area network to control the
projector.
•
If you are using Microsoft Internet Explorer, make sure it is version 7.0 or higher.
•
The screenshots in this manual are for reference only, and may differ from the actual
design.
1.
Enter the address of the projector in the address bar of your browser and press Enter.
to highlight Network Settings and press MODE/ENTER. The
to move the cursor and the press
/
until the SYSTEM SETUP: Advanced menu
/
to select On.
/
to select Off.
/
to enter the value.
Operation
35
Advertisement
Table of Contents
