PRO-PULSE N1F-GT-250/3.0-C Operator's Manual page 18

!
!
G
Fig.G-1
Fig.G-2
Fig.G-3
Fig.G-4
Fig.G-5
OPERATING INSTRUCTIONS
WARNING! Remove stones, loose pieces of wood and other objects from the
cutting area. The blade continues to rotate for a few seconds after the grass trimmer
is switched off. Allow the motor/blade to stop rotating before switching on again.
Do not rapidly switch off and on.
Switch On/Off
To switch the grass trimmer ON, squeeze the on/off switch, to switch the
grass trimmer off, release the on/off switch.
WARNING! The cutting head continues to rotate after the trimmer has been
switched off, wait until it has stopped then lay down the tool.
Replacing the spool kits. (Pic.G)
FIRST How to disassemble the spool.
1) Disconnect the mains plug.
2) Press together both locking devices (4) at the spool cover (3) and
remove spool cover. (Fig.G-1)
3) Remove the spool (2) from the spool cover. (Fig.G-2)
4) Remove the spring.
5) Clean off dirt and grass residues.
SECOND How to wind the string.
1) Hook the string in the groove as shown in Fig.G-3.
2) Wind the string as shown in Fig.G-4 and hook the two ends in the side
grooves.
3) Firmly place the cover on the spool and pull them approx.9 cm out of the
spool.(Fig. G-5)
18