Advertisement
Page 2 of 3
Step 3
Align the pre-drilled holes in the seats and support arms, attach
using 3 1/2" hex lag screws and flat washers.
Installation Tip: Seats may fit tigthly side by side, tilt the seats up
slightly as you tighten lag screws to pull them down flush against
the support arms.
Step 4
Position the assembled seats and support arms assembly
approximately 10" to 15" above the floor. Tip: A five gallon
bucket under the center point of the assembly works well.
Step 5
The three (3) base support legs are rotated for shipping purposes.
A single deck screw is pre-installed, rotate the leg 90 degrees and
align the pre-drilled holes. Secure the leg with a supplied deck screw.
Repeat for all three (3) legs.
IMPORTANT NOTE FOR THE NEXT STEPS: DO NOT OVERTIGHTEN LAG
BOLTS. DO NOT LEAN ON TABLE TOP OR SEATS WHEN ASSEMBLING.
Step 6
Insert a base support in the open space of each of the three (3)
support arms, centering each leg on the pre-drilled countersunk
holes of the support arms. Attach the base support uprights to the
seat blocks with 2 1/2" hex lag screws and flat washers. Ensure the
seats are centered with the support arms.
As of 10/2019
Advertisement
