Canon iP2700 Simplified Service Manual page 6

1-2. Service Call Errors (by Cyclic Blinking of Alarm and Power Lamps)
Error
Error
code
Carriage error [5100]
Line feed error [6000]
ASF cam sensor [5700]
error
Internal [5400]
temperature
error
Ink absorber full Japan:
[5B01]
Others:
[5B00]
Print head [5200]
temperature rise
error
EEPROM error [6800]
[6801]
VH monitor error [B200]
Cycles of
blinking of
Alarm and Conditions
Power
LEDs
2 times An error occurred in the
carriage encoder signal.
3 times An error occurred in the LF
encoder signal.
5 times An error occurred in the
ASF cam sensor (during
paper feeding from the rear
tray).
6 times The internal temperature is
not normal.
7 times The ink absorber is
supposed to be full.
8 times The print head temperature
exceeded the specified
value.
9 times A problem occurred in
reading from or writing to
the EEPROM.
10 times The print head voltage is
not normal.
(6/23)
Solution
(Check points and replacement items)
1) Foreign material or paper debris that
obstructs the carriage movement;
remove foreign material.
2) Smearing or scratches on the timing
slit film;
clean the timing slit film.
3) Part replacement:
- Timing slit film
- Carriage unit
- Logic board
1) Part replacement:
- Timing slit disk film
- Logic board
1) Part replacement:
- ASF / PE sensor unit
- Drive unit
- Logic board
1) Part replacement:
- Logic board
- Ink cartridge
1) Part replacement:
- Ink absorber kit
2) Ink absorber counter value in the
EEPROM;
reset the ink absorber counter.
1) Part replacement:
- Ink cartridge
- Logic board
1) Part replacement:
- Logic board
1) Part replacement:
- Ink cartridge
- Logic board