Table of Contents
Advertisement
Available languages
Available languages
fully read these instructions in their entirety
before using this product.
• Place your espresso machine on a stable,
heat resistant surface away from, for
example, an electrical heating plate or
near a fl ame.
• Plug the machine into a grounded electri-
cal socket. Verify that the voltage indicated
on the technical specifi cations on the
bottom of the unit corresponds to your
electrical installation.
• Ensure the drip tray and drip tray grid are
in place when using the machine.
Before using your machine for the fi rst time,
clean the system completely as follows:
• Open the lid and lift out the water contai-
ner using the handle (1). Fill the water
container with fresh, cold water (2).
• Place the water container back into the
machine by positionning it fi rmly in the wa-
ter container compartment (3) and close
the lid.
• Switch the appliance on by pressing
button (e) (4). The pump will work for 2
seconds to fi ll the system with hot water for
a cup of hot coffee from the start.
• Your espresso maker is equipped with
three fi lters designed for 1 cup, or for 2
cups of espresso using ground coffee,
or for E.S.E. (Easy Serving Espresso)
pods. The fi rst comes in the fi lter holder
(m), the other two are found in the
appliance's transport packaging.
• Choose the fi lter you wish to use and
place it in the fi lter holder (5). Put the other
two away in the tank lid (a).
• To ensure that the fi lter holder is in the cor-
rect position, turn the handle so it points to
the left at a 45 degree angle (6), place the
fi lter holder fl at against the brewing head,
then turn the handle towards the right (7)
as far as it can go.
• Place a container, as large as possible,
beneath the fi lter holder (8).
• As soon as the start/stop switch begins
to glow continuously, the coffee selection
buttons will glow continuously.
The machine is ready to operate
• Pressing the button for two coffees
(10) will now cause water to run through
the machines pipes.
Repeat this process fi ve times.
As an accessory, there is a fi lter car-
tridge (N° art. F088) not delivered with the
machine.
Using the various functions of
Using the various functions of
your espresso machine
your espresso machine
1. M
AKING ESPRESSO
The appliance will pre-brew the coffee be-
fore making each cup in order to bring out
the full fl avour for a satisfying cup of coffee.
The pump will work for 3 seconds, stop for
3 seconds, then continue with the cycle until
the end of the process.
. W
ITH GROUND COFFEE
For best results, we recommend that you
fi rst pre-heat the accessories (fi lter holder,
fi lter basket and cups) without putting in
ground coffee. To do this :
Fill the water container with fresh, cold
•
water (1) (2) (3) and turn on the machine
(4).
Put the fi lter holder and an empty fi lter
•
basket in place (6) (7), and place the
espresso cups underneath.
As soon as the coffee selection buttons
•
begin to glow continuously, the machine is
ready to operate.
Choose one of the coffee selection button
•
or
(9) (10). Take the pre-brewing
into account.
• The cups will fi ll with hot water. Once fi lled,
empty them.
After making your fi rst espresso and the
machine is warmed, the espresso cups can
then be pre-heated on the cup warming
plate.
. Preparing an espresso :
Fill the water container (1) (2) (3) and turn
•
on the machine (4).
Put the fi lter basket for one or two cups
•
into the fi lter holder (5).
Place some ground coffee in the fi lter
•
basket (1 or 2 measuring scoops). Do Not
Tamp the coffee into the coffee fi lter. Fill
the ground coffee to the top of the fi lter
9
Advertisement
Table of Contents
