Beltronics Vector 970 Operating Instructions Manual page 10

and is designed for use in high density microwave areas.
Factory setting is "
Note—once "
Selectable Features, the cty button must be pressed to engage
your selection.
X/K/Ka Band On or Off
Select "
depending upon your driving environment and selectivity
requirements. This mode is especially useful where falsing
may occur and disabling the offending band may be required.
Factory setting is on for all three Bands.
Auto-Mute On/Off
With "
Wideband Ka audio alerts.After the audio alerts, a "clicking"
tone keeps you quietly informed for as long as the signal is
present. This clicking becomes more rapid as the strength of
the Radar signal increases."
conveniently monitor extended encounters without having to
manually mute or adjust the volume setting.
With "
X, K, Super Wideband Ka and Laser audio alerts. This
standard setting is often preferred when background noise in a
vehicle is loud. Factory setting is "
Note: because of their urgency, Laser alerts are not affected.
Safety Warning System
When on, unit will provide a Message when signals from sws
transmitters are detected. Factory setting is on.
Audio/Visual Scroll Rate
When "
of audio/visual messages.When "
will provide a fast cycling of audio/visual messages. Factory
setting is "
".
" or "
","
, unit will provide several X, K, Super
"
, unit will provide a continuous series of
"
®
™
(sws )
" is selected, unit will provide a slow cycling
"
" is chosen in
" or "
enables you to
"
"
" is selected, unit
"
™