Accessories
Crutch Holder
Please note that the crutch holder can be attached on both the right and left side.
The illustrations in this manual are for attachment on the right side.
Step 1: To mount the crutches in the crutch holder,
slide them to the shortest setting and place them par-
allel in the wells of the rubber blocks (see Figure 1).
1
Figure 1
Step 3: Now the rubber belt is stretched over the
crutches and the handle is fixed in the mounting slot
.
(Make sure that the handle is positioned parallel to the
end edge of the base plate (see Figure 3).)
3
Figure 3
ORTHOSCOOT
NH1
®
Step 2: The handles face forward and the forearm
supports of the crutches
(see Figure 2).
2
inside = top
outside = bottom
Figure 2
Step 4: The crutches are now secured for travel.
Check that the crutches are secure before any journey.
To remove the crutches, pull the handle out of the
mounting slot. Now you can remove the crutches again
and adjust them to your height.
4
Figure 4
are interlocked together
51