Abicor Binzel TIG ABITIG MT Operating Instructions Manual page 37

®
ABITIG MT
NOTICE
• The maintenance intervals given are recommended values and refer to
single-shift operation.
• Maintenance and cleaning work may only be carried out by qualified
personnel (in Germany see TRBS 1203).
• Check coolant hoses, seals, and connections for damage and tightness.
Replace as necessary.
• Always wear your personal protective equipment when performing
maintenance and cleaning work.
The parts of TIG welding torches listed below are subject to wear and soiling.
This is why these parts must be subjected to regular maintenance and cleaning.
Sharpening the tungsten electrode
Sharpening the tungsten electrode depends on wear and must therefore be
carried out when required.
NOTICE
• The length of the electrode tip should be about 1-1.5 times the electrode
diameter.
Sharpening the tungsten electrode
Fig. 4
To sharpen the tungsten electrode, use a sharpening device with a diamond
plate. In doing so, observe the following:
• The point is sharpened longitudinally through the center axis.
• Automatic regulation of the tungsten electrode drive by gravity.
• Can be set for all electrode diameters.
• Continuous adjustment of the angle.
9 Maintenance and cleaning
EN - 17