Oakcastle DVD100 User Manual page 11

SYSTEM SET-UP
EN
MENU 1: SYSTEM SETUP
TV System (NTSC/PAL/AUTO): If TV system is selected, use the and
Enter buttons (Ref.12) to set the TV Type to AUTO, NTSC or PAL depending on the
color system of your TV.
This player conforms to the NTSC and PAL color systems. However, if you are in
the USA, Canada or Mexico, leave this setting on NTSC. If incorrectly set to PAL, the
TV picture may roll vertically. In this case, set the TV system to NTSC.
Screensaver: Turn screensaver on or off. If switched on, the screensaver will
come on when the unit idles or the image is paused for several minutes.
TV Type: Select the Aspect Ratio to match the connected TV (16:9, 4:3 LB ("Letter
Box"), or 4:3 PS ("Progressive Scan")).
Password: To set a new password for playing content rated at or above a rating
of your choice (selected using the 'Rating' sub-menu below), first select 'Password'
by pressing the Enter button (Ref.12). Enter the default password (0000) and press
Enter (Ref.12). Key in your new 4 digit password using the numeric buttons (Ref.4).
Press Enter (Ref.12) again to confirm your password. View or change the rating of
the content you wish to protect with a password by using the 'Rating' sub-menu
below.
Rating: Select the desired rating level from the following list: Kid Safe, G (All
ages), PG (Parental Guidance), PG 13 (Parental Guidance for children less than 13
years old), PG-R (Parental Guidance suggested for children under 17 years old),
R (Parental Guidance stronly suggested for children under 17 years old), NC-17
(Suitable for 17 years or above), Adult (Adults only).
Resume: Select to set auto-resume to 'Off' or 'On'. If switched on, the unit will
resume playback from the point where the disc was last stopped.
Default: Select to reset the unit to factory settings.
11