Concluding Routines; Checking Active Alarms; Checking Current Sbl; Handling Faulty Units - Ericsson MINI-LINK TN Operating Instructions Manual

4.4

Concluding Routines

Perform the following concluding routines before leaving the site.
4.4.1

Checking Active Alarms

To check active alarms:
1. In MINI-LINK Craft, in the Management Tree, right-click the unit.
2. Click Alarms.
3. If alarms are active on the Alarms and Status page, perform corrective
4.4.2

Checking Current SBL

To check Software Baseline (SBL):
1. In MINI-LINK Craft, in the Management Tree, right-click the NE.
2. Point to Tools, Software Upgrade and click Software Upgrade.
3. On the Software Upgrade page, identify the current SBL running on the
4. If the current SBL is not the desired SBL, upgrade the SBL by following the
4.4.3

Handling Faulty Units

If the old unit was faulty, follow the instructions in Handling Faulty Equipment,
Reference [5].
107/1543-HRA 901 20-V11 Uen B | 2015-12-01
actions for each active alarm as described in Alarm Descriptions, Reference
[2].
NE.
instructions in Upgrading or Downgrading a SW Baseline, Reference [11].
Replacing an NPU1 C with an NPU1 D
15