Coil-Tech Hub - Salford 2015 522 Assembly And Parts Manual

MNP522-30-15A INTL 2015 522 - 30ft Front Half Assembly and Parts Manual INTERNATIONAL
ITEM QTY. PART NO.
1 1 C90311
2 1 C91118A MULTI-LIP SEAL KIT FOR COULTER HUBS
3 1 GF641
4 1 BN16FCH 1"-14NF FLANGED CASTLE NUT GR. 8
5 1 BSR0415 1/4" x 1 1/2" LG ROLL-PIN PLATED
6 1 C90102
C90311 - BEARING KIT
1
06-2015

Coil-Tech Hub

CUP & CONE BEARING SET - 4 BOLT HUB (2 BEARINGS)
1/4"-28NF GREASE FITTING
DUST CAP
IMPORTANT
Recommended Install Procedure.
Note: Bearings must be properly grease packed.
1. Torque the spindle nut to 100 ft/lbs (135 Nm) to
properly seat the bearings in the races. Always rotate
the hub while tightening.
2. Back spindle nut off until it is just loose.
3. Re-torque to 40 (55 Nm) ft/lbs while rotating the hub.
4. Adjust the nut to align the nearest slot with the hole in
the spindle. Hub must be able to rotated relatively freely.
Also it should be tight enough so that it cannot slide
back and forth on the spindle more than .005" (0.13mm).
Salford Group Inc.
DESCRIPTION
C91118A - MULTI-LIP
2
SEAL KIT FOR COULTERS
Return to Contents
Page 39