Advertisement
1.
CH SW
2.
CH MODE
3.
CH RATE
4.
CH BPM SYNC
5.
CH DEPTH
6.
CH PRE DELAY
7.
CH HPF
8.
CH LPF
9.
CH EFFECT LEVEL
1.
FL SW
2.
FL RATE
3.
FL BPM SYNC
4.
FL DEPTH
5.
FL MANUAL
6.
FL RESONANCE
7.
FL SEPARATION
8.
FL HPF
9.
FL EFFECT LEVEL
10. FL DIRECT LEVEL
(0 -1)
OFF, ON
MONO
STEREO1
(0 - 2)
STEREO2
(0 - 100) 8000 – 20ms
OFF, 2, 3/2, 4/3, 1, 3/4, 2/3, 1/2, 3/8, 1/3, 1/4, 3/16,
(0 - 20)
1/6, 1/8, 3/32, 1/12, 1/16, 3/64, 1/24, 1/32, 3/128
(0 - 100) Determines the depth of the chorusing effect.
(0 - 80)
0 – 80ms
(0 - 17)
Flat – 800Hz
(0 - 14)
630Hz – Flat
(0 - 100) Adjusts the volume of the chorus effect.
(0 -1)
OFF, ON
(0 - 100) 8000 – 20ms
OFF, 2, 3/2, 4/3, 1, 3/4, 2/3, 1/2, 3/8, 1/3, 1/4, 3/16,
(0 - 20)
1/6, 1/8, 3/32, 1/12, 1/16, 3/64, 1/24, 1/32, 3/128
(0 - 100) Determines the depth of the flanging effect.
(0 - 100) -50 – 50
Determines the amount of resonance (feedback). Increasing the value will
(0 - 100)
emphasize the effect, creating a more unusual sound.
(0 - 100)
Adjusts the diffusion. The diffusion increases as the value increases.
(0 - 10)
Flat – 800Hz
(0 - 100) Adjusts the volume of the flanger.
(0 -100) Adjusts the volume of the direct sound.
[CH] CHORUS
Switches chorus on/off. This is a mono/stereo effect.
This chorus effect outputs the same sound from both L
channel and R channel.
This is a stereo chorus effect that adds different chorus
sounds to L channel and R channel.
This stereo chorus uses spatial synthesis, with the direct sound
output in L channel and the effect sound output in R channel.
Left-channel -only operation can be obtained by bringing
chorus effect level to 0.
Adjust the speed of the chorus effect. When BPM sync
is turned on, this parameter is disabled.
Adjusts the time from when the direct sound is heard until the
chorus sounds are heard.
Cuts the frequency range below the cutoff frequency.
No effect:0.
Cuts the frequency range above the cutoff frequency.
No effect: 14.
[FL] FLANGER
Switches flanger on/off. This is a stereo effect.
Adjusts the rate of the flanging effect. When BPM
sync is turned on, this parameter is disabled.
Adjusts the center frequency at which to apply the effect.
Cuts the frequency range below the cutoff frequency.
No effect: 0.
Advertisement
