Customer Viewable Fault Codes - Maytag Bravos X Series Technician Manual

FOR SERVICE TECHNICIAN'S USE ONLY
When rotating the cycle selector knob,

each click "indent" toggles the "Done"
LED as well as the associated cycle LED.
Press the POWER button at any time

to exit UI test mode.
Washer will exit UI test mode after 5

minutes of inactivity or unplugging the
power cord.
SOFTWARE VERSION DISPLAY MODE
To access Software Version Display Mode, perform
steps 1 and 2 of Activating the Service Diagnostic
Modes. Turn the cycle selector knob until the status
LEDs or display (if it exists) correspond as follows:
 "Rinse, Spin, and Done" LEDs On,
" " Displayed on 7-segment (if exists)
07
Sensing Soak Wash
NOTE: LED names may vary between makes
and models.
Press the START button to begin software
display mode.
Upon entering the software version display

mode, the Major, Minor, and Test version
numbers for the software are displayed by
alternating the state of the status LEDs and
display (if display exists) in one second
intervals; the process repeats following
a pause.
For example, if the s/w version is 02.01.07,
the following sequence would be displayed:
32 16 8
Sensing Soak Wash
Press the POWER button at any time

to exit software version display mode.
DO NOT REMOVE OR
Rinse Spin Done
4 2 1 Display
Rinse Spin Done
DESTROY
TACHOMETER VERIFICATION MODE
To access Tachometer Verification Mode,
perform steps 1 and 2 of Activating the Service
Diagnostic Modes. Turn the cycle selector
knob until the status LEDs or display (if exists)
correspond as follows:
 "Wash and Done" LEDs On, "
on 7-segment (if exists)
Sensing Soak
NOTE: LED names may vary between makes
and models.
Press the START button to begin tachometer
verification mode.
Tachometer verification uses the status

LEDs to represent the tachometer
07
frequency (basket RPM).
For example, slowly turn the basket
by hand; as the basket turns, the DONE,
SPIN, RINSE, and WASH status LEDs
will illuminate one at a time in a visually
repeating cycle. The LED timing is derived
from the tachometer signal itself.
Press the POWER button at any time

to exit tachometer verification mode.

CUSTOMER VIEWABLE FAULT CODES

There are 3 fault codes that may be visible to the
customer indicated by the following Status LEDs:
WASH LED ON (Long Fill Fault) – Refer to

"No Fill, Long Fill" on page 7 for information.
SPIN LED ON (Long Drain Fault) – Refer to

"Long Drain" on page 7 for information.
02
LID LOCK LED FLASHING CONTINUOUSLY
0 1

(Lid Lock Fault) – Refer to "Lid Lock Fault"
07
on page 6 for information.
FOR SERVICE FAULT AND ERROR CODES,
CONTINUE TO PAGES 6 AND 7
" Displayed
09
Wash Rinse Spin Done
PAGE 5
09