Installations; Specifications - Anvil MWA1400 Service Manual

ven should not be installed in any area where
nd steam are generated, because they may
ge the electronic or mechanical parts of the
install the oven next to a conventional
BEFORE YOU BEGIN, READ THE FOLLOWING INSTRUCTIONS COMPLETELY AND CAREFULLY.
e unit or above a conventional wall oven.
INSTALLING
icrowave oven in an ambient temperature
1. Empty the microwave oven and clean inside it with
a soft, damp cloth. Check for damage such as
an 104°F(40°C).
misaligned door, damage around the door or dents
inside the cavity or on the exterior.
the microwave oven on a sturdy and flat 2. Put the oven on a counter, table, or shelf that is
strong enough to hold the oven and the food and
e at least 10 cm(4 inches) from the wall.
utensils you put in it. (The control panel side of the
oven is the heavy side. Use care when handling.)
3. Do not block the vent and the air intake openings.
the microwave oven as far away as possible
Blocking vent or air intake openings can cause
damage to the oven and poor cooking results.
V, RADIO, COMPUTER, etc., to prevent
Make sure the microwave oven legs are in place to
ensure proper air flow.
rence.
4. The oven should not be installed in any area where
heat and steam are generated, because they may
damage the electronic or mechanical parts of the
unit.
Do not install the oven next to a conventional
surface unit or above a conventional wall oven.
5. Use microwave oven in an ambient temperature
less than 104°F(40°C).
6. Place the microwave oven on a sturdy and flat
surface at least 10 cm(4 inches) from the wall.
7. Place the microwave oven as far away as possible
from TV, RADIO, COMPUTER, etc., to prevent
interference.

INSTALLATIONS

INSTALLATIONS
10cm
10cm
2
3
EARTHING INSTRUCTIONS
This microwave oven is designed to be used in a fully
earthed condition.
It is imperative, therefore, to make sure it is properly
earthed before servicing
WARNING-
THIS APPLIANCE
MUST BE EARTHED
IMPORTANT
The wires in this mains lead are colored in
accordance with the following code:
Green-and-yellow:
Blue:
Brown:
As the colors of the wires in the mains lead of this
appliance may not correspond with the colored
markings identifying the terminals in your plug,
proceed as follows.
The wire which is colored green-and-yellow must be
connected to the terminal in the plug which is marked
with the letter E or by the earth symbol (
colored green or green-and-yellow .
The wire which is colored blue must be connected to
the terminal in the plug which is marked with the letter
N or colored black .
The wire which is colored brown must be connected
to the terminal in the plug which is marked with the
letter L or colored red .
2
accordance with th
Green-and-yellow
Blue:
Brown:
As the colors of the
appliance may not c
markings identifying
proceed as follows.
The wire which is co
connected to the ter
with the letter E or b
colored green or gre
Earth
Neutral
Live
The wire which is co
the terminal in the p
N or colored black .
The wire which is co
) or
to the terminal in the
letter L or colored re