Removing The Cooling Fan; High Voltage Transformer Removal; High Voltage Capacitor And Diode Removal - Anvil MWA1400 Service Manual

NOTE:
1. When removing the magnetron, make sure its
dome does not hit any adjacent parts, or it may be
2 2
Magnetron
Magnetron
Gasket
Waveguide
Bracket
Dome
Waveguide
7 . FAN ASSEMBLY REMOVAL
1) Release the screws and take out the fan assembly.
2) Seperate the fan motor, fan guide and fan.
8 . REMOVING THE TURNTABLE MOTOR
1) Remove the glass tray.
2) Remove the pulley shaft VERY CAREFULLY
3) Lay the unit down on its back.
4) Remove the turntable motor cover.
The turntable base cover is easily removed by
pinching the six parts with a wire cutting.
5) Disconnect the leadwire from the turntable motor
terminals.
6) Remove the screw securing the turntable motor to
the oven cavity ASS'Y
7) After rep lacing the motor, rotate the removed
turntable motor cover.
8) Fit the turntable motor cover's projecting part to the
base plate slit.
NOTE:
1. Remove the wire lead from the turntable motor
VERY CAREFULLY.
8 . HIGH VOLTAGE TRANSFORMER
REMOVAL
1) Discharge the high voltage capacitor.
2) Disconnect the leadwire from magnetron, high voltage
transformer, and capacitor.
3) Remove the screw holding the high voltage
transformer to the baseplate.
8
13