Advertisement
Display Messages
Abrt
The firing was stopped.
CPLt
Fired to completion. If the kiln is already hotter than the
programmed target temperature when you begin firing,
will appear.
CPLt
dELA
Delay mode. To delay the firing, enter delay time. To be-
gin firing without delay, leave Delay set at 00.00.
°F or °C (and temperature)
The target temperature (the temperature that the kiln
will fire to). Each segment in Ramp-Hold has a target tem-
perature. Single segment mode has only one target tempera-
ture.
FULL
Full power firing rate. At this setting the kiln will fire at its
fastest rate. There are two ways to select full power:
■
Select
in Single Segment mode.
SPd5
■
Select a rate of 1799°F/999°C at the
or
prompt in Ramp-Hold mode. A fast way to do
Ra 4
this is to press the Down Arrow key once from 0000.
will appear.
FULL
Hd (and time)
Hold time of a segment, shown in hours and minutes. Ex-
ample: 2 hours and 15 minutes = 02.15.
IdLE
The controller is ready for you to enter a program or to be-
gin a firing.
Ra 1
,
Ra 2
,
Ra 3
-on-
Firing has begun. A moment after
hear the relay(s) clicking.
ProG (Program)
Select this option to program a Ramp-Hold firing.
Ra 1, Ra 2, Ra 3 or Ra 4
Rate. This appears in Ramp-Hold programming for each
segment. 1, 2, 3 and 4 are segment numbers. Enter the rate
of temperature change for that segment. Rate is figured in
degrees of temperature change per hour. Examples:
A temperature rise of 100° in two hours = 50° rate.
A temperature drop of 200° in one hour = 200° rate.
Spd1, Spd2, Spd3, Spd4, Spd5
These are firing rates, or speeds, in Single Segment pro-
gramming. Select the firing speed with the Up Arrow key.
SStP
Skip Step. This message appears when you press the Up
Arrow key during a Ramp-Hold firing. If you press the Up
Arrow key again, the firing will skip to the next segment.
StoP
The firing was stopped by pressing START/STOP.
Strt
The Start message appears after programming a firing
and before Delay appears. Press START/STOP to make the
Delay prompt appear.
appears, you will
-on-
7
Advertisement
