Hayward AquaRite Installation Manual
Communication board for omni controls
Hide thumbs
Also See for AquaRite:
- Operation and installation manual (20 pages) ,
- Manual (20 pages) ,
- Operation and installation manual (10 pages)
Table of Contents
Advertisement
Quick Links
092718 RevB
AquaRite
AquaRite Communication Board for Omni Controls
Installation Manual
Contents
Overview................................1
Installation.............................1
Configuration.........................5
Operation..............................5
Troubleshooting....................6
HLAQRPCB
Hayward Pool Products
620 Division Street, Elizabeth NJ 07207
Phone (908)-355-7995
www.hayward.com
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Hayward AquaRite
Summary of Contents for Hayward AquaRite
- Page 1 092718 RevB AquaRite AquaRite Communication Board for Omni Controls Installation Manual Contents Overview........1 Installation......1 Configuration......5 Operation......5 Troubleshooting....6 HLAQRPCB Hayward Pool Products 620 Division Street, Elizabeth NJ 07207 Phone (908)-355-7995 www.hayward.com USE ONLY HAYWARD GENUINE REPLACEMENT PARTS...
- Page 2 OmniLogic or OmniHub automation control. The OmniLogic and OmniHub can turn the AquaRite on and off based on the filter pump's schedule and desired level setting. When using an HL-CHEM Sense and Dispense Module, the OmniLogic or OmniHub can also monitor the pool's ORP level and automatically increase or decrease chlorine production to maintain a desired ORP level.
- Page 3 The HLAQRPCB comes packaged with two cables; a short cable that will connect the HLAQRPCB to the AquaRite's main board and a 15 ft cable which will run through an enclosure knockout and back to the OmniLogic or OmniHub control.
- Page 4 OmniLogic Disconnect power to both the AquaRite and the OmniLogic before removing their panels. Use the included 15' 4 conductor communication cable to wire the units as shown below. Route the cable through appropriate knockouts making sure they are not shared with high voltage wiring. After the communication cable is fastened and secure, refasten the panels and reconnect power.
- Page 5 OmniHub Disconnect power to both the AquaRite and the OmniHub before removing their panels/cover. Use the included 15' 4 conductor communication cable to wire the units as shown below. Route the cable through appropriate knockouts making sure they are not shared with high voltage wiring. After the communication cable is fastened and secure, refasten the panels and reconnect power.
- Page 6 Before configuring your OmniLogic or OmniHub for operation with the AquaRite, verify that the AquaRite is enabled for use with these automation controls. Scrolling through the diagnostic displays (using the "Diagnostic" button on the AquaRite), make sure that the name configuration is NOT set to "AL-5". Follow the procedure below: Make sure AquaRite Main Switch is in the Auto position.
- Page 7 2. Communication issue between HLAQRPCB and AquaRite • Power cycle the AquaRite. • Check that the short cable is properly connected and secure to both the HLAQRPCB and AquaRite. • Check AL-X status. Refer to Configuration and Pool Preparation section on page 5. •...
- Page 8 Hayward is a registered trademark and Hub is a trademark of Hayward Industries, Inc. © 2019 Hayward Industries, Inc. All other trademarks not owned by Hayward are the property of their respective owners. Hayward is not in any way affiliated with or endorsed by those third parties.
Need help?
Do you have a question about the AquaRite and is the answer not in the manual?
Questions and answers