C) Adjusting The Shock Absorbers - Reely Stagger Operating Instructions Manual

c) Adjusting the shock absorbers

Front axle Rear axle
At the upper end of the shock absorber (A), the spring preload can be adjusted by inserting plastic clips.
The shock absorbers on the front and rear axle can be mounted in different positions above the shock absorber
bridge (B) and on the bottom suspension arm (C). The manufacturer has preconfigured an optimal position, therefore
changes should only be made by professional drivers.
Always ensure that the shock absorbers on each axle are level (i.e. on the left and right wheel of the front or rear axle),
otherwise the vehicle may not respond correctly.
Professional drivers can also use springs with a different hardness grade or fill the shock absorbers with a shock
absorber oil of a different viscosity. The installation of aluminium shock absorbers, which are adjustable by knurling,
would be possible.
As is the case with full-size vehicles, the shock absorbers (and the rubber seals in the shock absorbers) are wear-
able parts. If oil leaks from the shock absorbers (e.g. the suspension arm is coated in oil, or there is dripping oil), the
gaskets or shock absorbers must be replaced.
48