Advertisement
5.5 CLEANING THE DETERGENT DRAWER
The detergent drawer should be kept clean, removing all solid
deposits.
To simplify this operation, completely remove the detergent
drawer (pull the drawer fully out, press in the zone marked
PUSH and then remove completely).
Remove the siphon "A" and clean all parts with hot water.
Fully re-insert the siphon and remove any detergent deposits
before putting the drawer back in position.
5.6 CLEANING THE WATER INTAKE FILTERS
The machine is fitted with a filter which protects the water intake valves.
The filter is in the fitting on the intake hose which is connected to the tap
The filter must be cleaned if the washing machine is not taking in water
or the amount of water is insufficient.
To clean, proceed as follows:
1. Remove the mains plug to disconnect the appliance from the
electricity supply.
2. Turn off the water tap.
3. Unscrew the intake hose fitting from the tap.
4. Unscrew the intake hose fitting from the tap.
5. Clean the filter with water, with the aid of a small brush.
6. When screwing the intake hose fitting back into place, check that the filter is posi-
tioned correctly.
5.7 Periodic cleaning
Carry out periodic cleaning to keep the appliance in good working order (see
CLEANING AND MAINTENANCE section) to prevent the build-up of limescale,
unpleasant odours and mould. A descaler can be used, following the instructions
supplied with the descaler. Clean the dispenser drawer at least once or twice a
month to avoid the build-up of detergent.
Periodically check the water supply filters. See the procedure outlined in the ma-
nual.
EN
22
Advertisement
