Advertisement
4.14 INTERRUPTING OR CHANGING THE WASHING PROGRAMME
The washing programme in progress can be interrupted at any moment:
1. Press the "Start/Pause" button for about 3 seconds: the display shows the word PAUS
(for 1 second) alternating with the time remaining until the end of the cycle (for 1 sec-
ond). The Start/Pause light flashes on and off.
Programmes can also be interrupted by turning the programme/temperature setting
knob while the cycle is in progress.
2. To change the washing programme, simply turn the programme knob to select the
new programme; there is no need to set the appliance in pause status. The new cycle
will be carried out completely, beginning from the start. If the tank had already been
filled with water during the previous cycle, the water intake phase will be omitted from
the new programme.
3. To restart the cycle, press the Start-Pause button again.
4.15 PROGRAMME END
Washing programmes are completed automatically. The word END appears on the display
and the "Time remaining" light goes out.
1. Switch the appliance off by turning the programmes knob to OFF
2. Unload the laundry from the drum.
3. Leave the door ajar to allow the interior of the washing machine to dry out.
4. Turn off the water intake tap.
If during the initial spin speed setting stage, the "no spin" mode with stop with tank full
(spin speed set as 0) was selected, at the end of the washing programme the word STOP
appears on the display, alternating with ---- (spin speed of 0) and the spin light is on.
To proceed with the pump-out and spin, press the spin selection button twice. The appliance
restarts the cycle with the pump-out and spin. To select the spin speed required, press the
button until the chosen speed is displayed. To pump out the water from the tank without per-
forming the spin, press the spin selection button until the display indicates speed of 0: the
pump-out will be run without spin.
EN
18
Advertisement
