Schwank MonsterFans MF-C12 Use Instruction page 13

Now assemble the fan blades. Use the M10 x 100 mm screws. Pay attention to an exact
alignment of the rotor blades and use threadlocker glue. When assembling, make sure to
connect all retaining brackets (parts list no.6) to each other. Then install the bottom plate
(parts list no 8) with the screws M5 x 12 mm (no 7).
Now lay the wiring to the control unit. Controller box.
Use your electrical cable.
Now install the Controller Box. We recommend installing it at a height of approximately 1.6 m.
Use the following cable type: at least 4 x 2.5 mm² shielded cable.
Controller Box: Fan Motor wiring:
www.monsterfans.com info@monsterfans.com
13