Table of Contents
Advertisement
Available languages
Available languages
Parts supplied:
Brackets (2)
Vinyl caps (2)
LOCATION REQUIREMENTS
Recessed Area and Closet Installation Instructions
IMPORTANT:
The stacked washer/dryer can be installed in
an enclosure. Check the locations of the water supply faucets
and grounded electrical outlets. Depending on your application,
washer fill hoses longer than those supplied with the washer/dryer
may be needed.
0"/1"
0"/1"
(0 mm/25 mm)
(0 mm/25 mm)
0"/1"
0"/1"
(0 mm/25 mm)
(0 mm/25 mm)
If the water supply faucets, electrical outlets, or power cord
need modification, have a qualified plumber or electrician make
the changes.
Pan-head screws (6)
0"/1"
0"/1"
(0 mm/25 mm)
(0 mm/25 mm)
3"
3"
(76 mm)
(76 mm)
48 in.
48 in.
(310 cm
68
⁄
" Min.
3
(310 cm
4
(1746 mm)
65
/
"
3
4
(1670 mm)
69
⁄
" Max.
1
2
(1765 mm)
24 in.
24 in.
(155 cm
(155 cm
3"
3"
(76 mm)
(76 mm)
0"/1"
0"/1"
(0 mm/25 mm)
(0 mm/25 mm)
UNINSTALL WASHER AND DRYER
IMPORTANT:
they must be uninstalled.
If you need to uninstall your washer or dryer, see the Installation
Instructions that came with your model for tools required.
Uninstalling Your Washer
1. Turn off the water faucet(s).
2. Unplug the power supply cord.
3. Slowly loosen the fill hose(s) at the faucet(s) to relieve the
water pressure. Use a sponge or towel to absorb the released
water.
4. Remove the fill hose(s) from the back of the washer. Drain
water in the hose(s) into a bucket.
5. Remove the drain hose from the wall/floor drain pipe or utility
sink and drain any water in the hose into a bucket.
Uninstalling Your Dryer
1. Disconnect the power supply.
2. Remove the drain hose from the floor drain pipe or utility sink
and drain any water in the hose into a bucket.
IF YOUR WASHER OR DRYER IS STILL
IN ITS PACKAGING
2
2
)
2
)
2
Position the packaged washer or dryer close to its final position.
Cut the packaging as follows:
2
2
Washer: Cut plastic film along dotted cut line around the
n
)
2
)
2
base. Remove the packaging. Do not remove the shipping
bolts.
Dryer: Cut around top and down corners along dotted cut
n
lines. Discard carton top, corner posts, and sides. Leave
carton bottom underneath dryer.
If your washer and dryer are already installed,
3
Advertisement
Table of Contents
