Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Black+Decker BDCCS18
Summary of Contents for Black+Decker BDCCS18
- Page 1 BDCCS18...
- Page 4 20 21...
-
Page 5: Intended Use
ENGLISH Intended use Use of an RCD reduces the risk of electric shock. Your BLACK+DECKER BDCCS18 circular saw has been 3. Personal safety designed for sawing wood and wood products. This tool is a. Stay alert, watch what you are doing and use common intended for consumer use only. -
Page 6: Cutting Procedures
ENGLISH (Original instructions) d. Store idle power tools out of the reach of children and Charging improperly or at temperatures outside the do not allow persons unfamiliar with the power tool or specified range may damage the battery and increase the these instructions to operate the power tool. -
Page 7: Lower Guard Function
(Original instructions) ENGLISH Kickback causes and related warnings If saw is accidentally dropped, lower guard may be bent. Raise the lower guard with the retracting handle and make kickback is a sudden reaction to a pinched, bound or sure it moves freely and does not touch the blade or any misaligned saw blade, causing an uncontrolled saw to lift other part, in all angles and depths of cut. -
Page 8: Electrical Safety
Chargers (may not be included) remaining on continuously. The pack is fully charged and Use your BLACK+DECKER charger only to charge the may be used at this time or left on the charger. battery in the tool with which it was supplied. Other batter- Note: Recharge discharged batteries as soon as possible ies could burst, causing personal injury and damage. - Page 9 (Original instructions) ENGLISH Installing and removing the battery pack from the The charger and battery pack may become warm to touch tool (may not be included) while charging. This is a normal condition, and does not indicate a problem. To facilitate the cooling of the battery Warning! Before attempting any of the following operations, pack after use, avoid placing the charger or battery pack make sure that the tool is switched off and unplugged and that...
- Page 10 ENGLISH (Original instructions) Shoe Adjustment For 90° Cuts Figure E illustrates typical hand support. The shoe (5) has been set by the factory to assure that the blade is perpendicular to the shoe at 0° bevel setting. IF REALIGNMENT IS NEEDED: Adjust the saw to 0°...
-
Page 11: Troubleshooting
The performance of your tool depends on the accessory used. cause injury. BLACK+DECKER accessories are engineered to high quality A pocket cut is one that is made when the edge of the material standards and designed to enhance the performance of your does not push the lower guard open, but the bottom edge of tool. -
Page 12: Ec Declaration Of Conformity
, uncertainty (K) 1.5 m/s h, W EC declaration of conformity MACHINERY DIRECTIVE BDCCS18 Circular Saw Black & Decker declares that these products described under “technical data” are in compliance with: EN62841-1:2015 , EN62841-2-5:2014. These products also comply with Directive 2006/42/EC, 2014/30/EU and 2011/65/EU. - Page 16 Australia Black & Decker (Australia) Pty. Ltd. Tel. 03-8720 5100 20 Fletcher Road, Mooroolbark, 03-9727 5940 Victoria, 3138 New Zealand Black & Decker Tel. +64 9 259 1133 5 Te Apunga Place +64 9 259 1122 Mt Wellington Aukland 1060 United Kingdom &...
Need help?
Do you have a question about the BDCCS18 and is the answer not in the manual?
Questions and answers