EverFocus Smart Heavy-Duty Vehicle TPMS Solution Quick Installation Manual page 8

Sensor Installation order
1
3 4
7 8
11 12
15 16
2. Put the supplied EV-S01 Battery into the sensor, then tighten the cap until the water-proof
ring is thoroughly covered.
Water-proof Ring
3. Screw the sensors to the corresponding tires follow the installation order.
1) Remove the original valve cap of the tire, clean the surface of the valve stem then put
the supplied EV-S01 Lock Nut into the valve stem.
2) Screw the EV-S01 Lock Nut until it reaches the end of the valve stem.
3) Rotate the sensor clockwise to screw it to the valve stem. Make sure the sensor is
completely screwed to the valve stem.
2
5 6
9 10
13 14
17 18
7
Smart Heavy-Duty Vehicle TPMS Solution