EverFocus Smart Heavy-Duty Vehicle TPMS Solution Quick Installation Manual page 19

4. The sensors detected will be displayed on the screen. If you have a total of 6 sensors, the
system should detect at least 6 sensors.
5. Screw the sensors to the corresponding tires follow the installation order. (See 2.2 Sensor
Installation)
3.5.2 Pair a Single Tire
To pair a single tire with a sensor:
1. Turn on the main unit. In Normal mode, press Temperature Unit button
Unit button for 5 seconds to enter the Learning mode. Press Unit button
enter the tire order selection mode. In this mode, use Unit button
order.
2. Put the supplied EV-S01 Battery into the sensor then put the sensor near the main unit, the
system will start to search the nearby sensor which is powered but is not receiving any tire
pressure.
3. After the sensor is detected, screw the sensors to the corresponding tire (See 2.2 Sensor
Installation).
4. When the sensor is successfully paired with the tire, the main unit will beep and its
backlight will flash, then the system will returns to Normal mode.
Smart Heavy-Duty Vehicle TPMS Solution
Sensor Detected
Tire waited for pairing
Sensor Detected
Tire order
18
and Pressure
again to
to select the tire