Table of Contents
Advertisement
2.4 Repeater Installation
The repeater repeats the signal from the sensors. It is recommended to install the repeater in
the vehicle's rear area.
1. Connect the power cable to the 9 ~ 30V battery power, red wire to ACC power and black
wire to GND.
2. Connect the antenna cable with the supplied 10m antenna extension cable. See 2.3
Antenna Extension Cable Installation for more details.
3. Fix the repeater in the vehicle's rear area using cable ties. When the power is supplied, the
LED on the repeater will turn on and blink. If the LED does not turn on, please check the
power source. If the LED does not blink, please check the antenna connection.
2.5 Trailer Receiver Installation
The trailer receiver receives the signal from the sensors and transmits the signal to the main
unit. It is recommended to install the transceiver on the chassis or the vehicle's side, near the
middle-front of the rear tires.
1. Connect the power cable to the 9 ~ 38V battery power, red wire to ACC power and black
wire to GND.
2. Connect the antenna cable with the supplied 10m antenna extension cable. See 2.3
Antenna Extension Cable Installation for more details.
3. Fix the repeater on the chassis or the vehicle's side using cable ties or screws. When the
power is supplied, the power LED (red) on the trailer receiver will turn on and blink. If the
power LED does not turn on, please check the power source. When the trailer receiver is
receiving signals from the sensors, the sensor LED (green) on the trailer receiver will turn
on. If the sensor LED does not turn on, please check the antenna connection.
Smart Heavy-Duty Vehicle TPMS Solution
10
Advertisement
Table of Contents
