Linkcom LINK 2800 DECT Operating Instructions Manual page 22

16 3 Programming mode
Function
Provider selection
No provider code is dialled.
Provider selection
The provider code is dialled each time an external call is made.
Factory setting: 0
3.2.16 Parameter query
Function
Parameter display
A handset can be used to read the current setting for different
parameters. After entering the relevant parameter code and confirming
#
this with , replace the telephone receiver. You will then receive a call
from the LINK 2800 DECT/GAP and the parameter code and the current
status will be shown on the telephone display.
Flash time example:
#95123#
Input
ms)
Display registered handsets example:
#9515#
Input => output e.g. 1121314150607081 => handsets 1, 2,
3, 4, 8 are registered.
Display call assignment example:
#95111#
Input
subscribers 1, 3, 6 => line 2: subscribers 3, 4, 5 and hunt group call.
Other examples:
Output:
Line assignment (0...2)
Authorisations (0...3)
Fax subscribers (0...1)
Direct dialling in (0...1)
Parameter
code
46
46
Parameter
code
51
=> output 23-010 => flash time (10*10 ms = 100
=> output e.g.1136_23459 => line 1:
Parameter code:
12
13
14
21
Inputs
0 #
1 #
Inputs
#
3 Programming mode
3.2.17 Parameter reset
Function Parameter
code
Parameter reset 90
All parameters are reset to the factory settings, the handsets remain
registered unchanged.
3.2.18 Resetting the LINK 2800 DECT/GAP
Function Parameter
code
Reset
LINK 2800 DECT/GAP 91
The LINK 2800 DECT/GAP is reset to the factory settings.
All parameters are reset to the factory settings, all handsets are de-
registered. The PIN is reset to 0000. Entries in the blacklist are deleted.
17
Inputs
#
Inputs
#