Mounting/Commissioning - Linkcom LINK 2800 DECT Operating Instructions Manual

4 Tones
Tones
Description of the tones
Dial tone
(1.2 s tone, 1.2 s pause, repeated after 5 s)
Free tone
(1.0 s tone, 4.0 s pause)
Busy tone
(1.0 s tone, 1.0 s pause)
Call waiting
(0.02 s tone, 6.0 s pause)
Call on hold/MOH
(1.5 s tone, 1,5 s pause, repeated after 6 s)
Failure tone
(0.8 s tone, 0,5 s pause)
Positive acknowledge tone
(1.0 s tone)
Negative acknowledge tone
(0.2 s tone, 0.2 s pause)
DDI tone
(0,02 s tone, 0,02 s pause, repeated after 2 s)
Tone Pause
1

Mounting/commissioning

1 Mounting/commissioning
Selecting a The LINK 2800 DECT/GAP is designed for wall mounting in interior rooms.
suitable Please note that the device must not be fitted in the immediate vicinity of
location any other electronic devices such as hi-fi systems, office machines, satellite
receivers or microwave ovens. This prevents any interference between the
devices. In addition, the device should not be installed near heat sources
(e.g. radiators or in direct sunlight).
Radio coverage The LINK 2800 DECT/GAP must be able to establish a radio link to the
registered handsets. Before determining the final mounting position, you
should therefore check by using the field strength indicator of a
registered DECT handset that your desired location ensures the optimum
connection quality. The position of the aerial is a critical factor here.
Owing to the digital transmission in the frequency range used, there may
be radiowave "blind spots" even within the specified range, depending on
the layout of the building. This results in a loss of transmission quality.
However, just a small change in position will often restore normal
transmission.
Wall mounting Follow the steps given below to install the LINK 2800 DECT/GAP:
1. Drill two 6 mm diameter holes into the wall at a distance of 60 mm
apart.
2. Insert the rawlplugs and screw in the screws until they protrude
approx. 5 mm clear of the wall.
3. Connect the external aerial to the
appropriate socket (only LINK 2800
DECT/GAP L.Range).
4. Connect the LINK 2800 DECT/GAP to
the power supply.
5. Connect your analogue telephone
connection to the LINK 2800 DECT/GAP
using the cable supplied.
6. Mount the LINK 2800 DECT/GAP onto
the screws.
5
60 mm