Linkcom LINK 2800 DECT Operating Instructions Manual page 20

12 3 Programming mode
3.2.9 Flash time
Function
Flash time
The flash time can be changed according to line requirements, in
increments of 10 ms.
Factory setting: 27, which is equal to 270 ms
3.2.10 CLIP
Function
CLIP
Evaluation of number presentation (CLIP) is deactivated.
CLIP
Evaluation of number presentation (CLIP) is activated. The number
transferred is sent to the called handset.
Factory setting: 1
3.2.11 Changing the PIN
Function
PIN change
Access to programming mode can be protected using the four-digit PIN.
The PIN only needs to be entered if a new PIN has been set beforehand
in programming mode. To change the PIN, activate programming mode,
enter the new PIN twice and confirm this by pressing
confirmed by the positive acknowledgement tone. Programming mode
can then only be accessed again by entering the new PIN once more. To
restore the factory setting, change the PIN to 0000.
Parameter Inputs
code
23 0...255 #
Parameter Inputs
code
24 0 #
24 1 #
Parameter Inputs
code
26 new PIN new PIN #
#
. The change is
3 Programming mode
If you forget the PIN, the LINK 2800 DECT/GAP can only be reset by the
Customer Service department.
Factory setting: 0 0 0 0
3.2.12 Music on hold
Function Parameter
code
MOH 27
An external caller on hold hears no music on hold.
MOH 27
An external caller on hold hears music on hold.
Factory setting: 1
3.2.13 Blacklist
Function Parameter
code
Blacklist 40
The subscriber is not monitored by the blacklist.
Blacklist 40
The subscriber is monitored by the blacklist.
Factory setting: 0
Function Parameter
code
Exclusion area 41
Entry is stored.
13
Inputs
0 #
1 #
Mob. no. Inputs
1...8 0 #
1...8 1 #
Entry Inputs
no.
1...5 No.
max. 6
figures #