Table of Contents
Advertisement
MASTER CONFIGURATION
Configuring a MASTER unit, allows to control using the AHlink application,
all the units installed in the same room. When the unit is configured as
MASTER, the AHlink signal is always active and you can control all the
signals installed. First, do you need to link the units using RJ45 cables
connected in the AHnet ports. The cable connected to the MASTER
unit, have to be crossover in order that the MASTER unit can send the
AHnet commands to the rest of the units. Refer to next figure to connect
all the units to be controlled by the MASTER unit.
RJ45 crossover and straight-thru information
26
Advertisement
Table of Contents
