Table of Contents
Advertisement
MOUNTING GUIDE AHDSR42W UI
The DynamicSpeaker is available in a special version that is prepared to
be mounted from below the table with a veneer finishing on the lid of the
device to match the table. This special version is supplied without stainless
steel cover plate and buttons.
Included in this version are all necessary brackets.
Is controlled by means of AHnetT or AHlink.
Veneer
To veneer the lid of the DynamicSpeaker the dimensions are specified in
the document Pattern Hole.
Different materials can be used to veneer the unit. Maximum thickness
of the veneer: 8mm [0,315"]. Maximum weight: specified in the Pattern
Hole document (veneer thickness + glue < 8).
Fixation
Veneer can be glued or taped to the lid.
When veneering the device the pressure applied must not exceed 1.5
Kg evenly distributed on lid surface.
• Use glue or tape depending on the mechanical properties of the
materials to be joined (lid and veneer). The lid is made in painted steel.
• Surface energy, dilation, temperature and humidity are factors must be
considered to choose the best option.
• Double sided tapes 3M VHB family are recommended (check the
compatibility between the materials to tape / glue).
11
Advertisement
Table of Contents
