Sensio FINLAY Installation Instruction

furniture lighting solutions
IMPORTANT:
Please read these instructions before commencing installation and retain for future reference.
Components
• ,
.. ..
' •
' •
'•
'•
• .
'•
• ,
' •
' •
'•
'•
• ,
• ,
• ,
X Cabinet Mirror
Important Safety Information
Please read these instructions carefully before attempting to install this
product. It is advisable to keep these instructions in a safe place for
future reference.
We recommend that you consult a qualified electrician. All
electrical installation must be carried out in accordance with
current IEE wiring regulations (BS7671).
These products must not be modified, if any modification are made, it
may invalidate the warranty and may render the product unsafe.
This fitting shou ld be used indoors only.
Safety Instructions
1. Before commencing installation or maintenance, isolate the main
electrical supply for the appropriate circuit at the fuse board.
2. This product is only suitable for connecting to a 220-240V SOHz supply.
3. The mirror should be mounted onto a secure surface.
Waste Electrical & Electronic Equipment (WEEE)
The symbol on the product, or on the document accompanying the product, the crossed out wheelie
bin symbol, indicates that this product may not be treated as household waste.
Instead it shall be handed over to the applicable collection point for the recycling of electrical and
electronic waste.
Sensio House, Unit 7, Speedwell Road, Whitwood, Castleford, West Yorkshire, WFlO SPY
www.sensio.co.uk
Technical drawings for illustration purposes only, Sensio have the right to change any information
without prior notice. Make sure you check all hole cut outs before work commences.
1 x FINLAY
LED CABINET
MIRROR
CODE: SE30826CO
l l l l
4 x Wall Plugs 4 x Screws
1 x Instructions
4 x Washers
• If in doubt installation must be carried out by a qualified
electrician.
• Install on smooth flat surface(s) only.
• Do not exceed or stretch the cable length of each LED wire.
• There are 60 x 0.07 high power LED' s in this mirror.
• 650mm (W ) x 600mm (H) x 105mm (D)
• Please make sure the LED' s are working correctly before
commencing installation.
4. When installing please take care to avoid water pipes, joints
and electrical cables.
-
Tools required
1 x Pencil
1 x Screw driver 1 x Power Drill