Advertisement
furniture lighting solutions
Lay the mirror on a flat surface with the front glass panel facing upwards.
Using a cross-headed screwdriver, remove the four screws, metal and
plastic washers from the metal casing at the rear of the mirror (diag. A).
Carefully lift the front glass panel off the mirror (diag. B) and place it onto a
soft, flat surface to avoid damage to the glass.
Mark the position of the fixing holes in the back on the wall, avoiding any
wiring or water pipes.
Drill and prepare the holes for the screws ensuring that the wall is solid
material.
Mount the metal black box of the mirror onto the wall and secure tightly.
Pierce the protective IP rated rubber grommet (this will isolate and trap
any steam to ensure maximum safety).
Inset a 3- Core cable through the pierced hole in the protective cover and
then thread the cable through from behind the back box into the power
supply (diag. E).
ZONE
0
Inside the bc1th or shower
Must
be SEI
V
(1
)\J max)
due to wc1ter submersion
lvlm1mum rat111g of IP67
2
The area stretching to 60cm
outside the bath or shower and
60cm from water outlet of sink. An
IP rating of at least IP44 is required.
The light fitting is suitable for
installation in zone 2 and the
outside zones.
Maintenance & Care
• Ensure that the power is disconnected prior to cleaning.
• To keep the finish of this product, wipe over with soft cloth periodically.
• Do not use harsh chemical solvents, this may dis-colour or damage the finish.
Sensio House, Unit 7, Speedwell Road, Whitwood, Castleford, West Yorkshire, WFlO SPY
Uk
WWW.Sen Si O. CO.
Visit our website for on line instructions.
Technical drawings for illustration purposes only, Sensio has the right to change any information
without prior notice. Make sure you check all hole cut outs before work commences.
1 x FINLAY LED CABINET MIRROR
diag. B
OUTSIDE ZONES. Anywhere outside zones 0, 1 & 2. Where water jets are not used for cleaning purposes, the general rules of 657671 apply.
. . . .
. . . .
. . . . . .
. .
. . . .
.
.
.
. . . . . .
. . . .
.
. . . .
. .
. .
.. ..
.. ..
.. ..
.. ..
..
diag.C
Using a flat-headed screwdriver, securely connect the 3-Core cable to the
terminal block inside the metal casing.
Simply attach the labelled male and female connectors to activate the LED
light of the mirror panels. Attach side mirror panels securely onto the
metal back box mounted on the wall; secure tightly using the four screws
shown in diag. C.
Fit the two packs of holding bracket by twisting the nut of the bracket
shown in diag. D. Slide the glass shelf onto the fitted brackets.
Finally, switch on the mains electrical supply and activate your new mirror
cabinet by pulling the pull cord.
diag.D
----{�iJli::J----
Blue (N)
Eanh
----{}II)�)----
Brown (L)
diag. E
furniture lighting solutions
12102016
Neutral (N)
Eanh ("'$" )
Live (L)
Advertisement
