Positioning The Childseat - Britax PINNACLE CLICKTIGHT User Manual

Positioning the Child Seat: Booster Mode
LUAS with CLICKTIGHT
Before you begin:
IMPORTANT: It is not necessary to use lower anchors or tether
to position this child restraint in booster mode. To use this seat
in booster mode without lower anchors, see instructions for
Securing Your Child on page 20.
IMPORTANT: Use lower anchors only to position this child seat
in your vehicle seat. Secure your child using the vehicle's lap-
shoulder belt system.
• Check that your vehicle has lower anchors.
• Check that your vehicle has a top tether anchor.
• Loosen the tether and place it over the child seat back to
keep it from becoming pinned between the child seat and
vehicle seat during positioning.
• Adjust the child seat to the upright position and place
forward facing on the vehicle seat.
Release the buckle and open
1
the CLICKTIGHT to access
the lower connectors.
* Locate the two slots in the
CLICKTIGHT cover.
* Squeeze the CLICKTIGHT
release levers.
Route the lower connector
2
strap along the green belt path
and firmly press the lower
connectors onto their adjacent
lower anchors.
* A click confirms attachment.
* Verify that the strap is not
twisted.
Pull the end of the lower
3
connector strap to remove
slack.
IMPORTANT: Only remove slack
from the lower connector webbing.
Overtightening the webbing may
prevent the CLICKTIGHT from
properly securing.
16
Positioning the Child Seat: Booster Mode
Close the CLICKTIGHT.
4
* A click confirms the
CLICKTIGHT is secure.
Firmly press the tether hook
5
over a designated vehicle
tether anchor. Remove slack.
Secure excess webbing with
6
the elastic strap.
OR
OR
17