AUT-DT1
AUTOMATIC TOUCH ON/OFF
AUT-DTM2
AUTOMATIC METERED TOUCH
AUT-DP3
AUTOMATIC TOUCHFREE
AUT-DPM4
AUTOMATIC METERED TOUCHFREE
Features:
•
Can be used with most Watermark deck mount spouts and finishes
•
No visible sensor – turns the spout itself into the sensor
•
Battery operated – no need for hardwiring
•
Safety timeout so water doesn't run indefinitely (DT1 and DP3 only)
•
Metered option to satisfy local codes for public bathrooms
•
No temperature control – water should be pre-tempered
Specifications:
1. Working water pressure: 20 PSI to 85 PSI
2. Working water temperature: 45°F to 120°F
3. Working environmental temperature: 35°F to 100°F
4. Flow Rate: 1.2 GPM lavatory, 1.75 GPM kitchen
5. IP55 water and dust protection
6. 6V CR-P2 lithium battery (included)
7. 12 second metering cycle (DTM2 and DPM4 only) provides 0.24 gallons per cycle
8. Shipping weight (lbs.): 10
9. Shipping dimension (in.): 29 x 12 x 4
Note:
•
DO NOT USE PLUMBER'S PUTTY ON ANY OF THE BRASS COMPONENTS
This will cause the finish to tarnish and void the warranty. A non-corrosive Alkoxy Silicone is
recommended.
•
DURING SWEATING OF LINES DO NOT OVERHEAT CASTING
Overheating may cause damage to internal mechanism and void the manufacturer's warranty as well
as increase the risk of scalding.
•
COPPER ADAPTORS MAY BE REQUIRED TO COMPLETE YOUR INSTALLATION
•
Not for use with metallic sinks or counters.
Diagram A - Dimensions
DECK MOUNT AUTOMATIC FAUCET
INSTALLTION FOR
Rev. 9/19
P a g e
| 1