4 . AT TA C H M O N I T O R A R M A N D C A B L E
•
Insert the monitor arm into handlebar and make sure to push all
the way in.
•
Use the 6mm Allen wrench provided to tighten the screw on the
right-hand side of the slot.
•
Locate the velcro strap found in the toolbag. Loosely attach
the monitor cable to the monitor arm, allowing the cable to
pass through freely when adjusting the handlebar height.
•
Tuck the monitor cable behind the water bottle holder to prevent
it from rubbing against the flywheel.
5 . S TA B I L I S I N G T H E B I K E
•
If the bike rocks after being set down, turn each leveling foot
clockwise (when viewed from above) until it rests firmly on
the
ground.
•
If you're having trouble turning them, you may need to lift the
bike and loosen the feet first using the wrench in your toolkit.
6 . P O W E R O N
•
Insert the power cord into the port just above the rear stabiliser.
•
Plug the power supply into a plug socket. The green LED on the
power supply should light up.
•
Press the top button on the back of the touchscreen to power it on.
•
Follow the on-screen prompts to connect to your WiFi network and
activate your bike.