Troubleshooting - Silvercrest SMZS 1600 A1 Operation And Safety Notes

5 Troubleshooting

Before contacting your authorised Royal Appliance dealer, Royal Appliance service partner or appli-
5 Troubleshooting
ance market, first follow the procedure in the following table to check if you can handle the problem
yourself.
WARNING:
Danger of injury! Never use a defective appliance! Always switch off the appliance and disconnect
it from the mains before starting troubleshooting
power cord".
Problem
The appliance will The socket does not carry
not start current.
Power cord is damaged.
Appliance sud- The overheating protection
denly stops vacu- has tripped, possibly due to
uming and blocked suction channels, fil-
switches itself off ters, or similar.
The red warning- The dust container is full.
light is on
Nozzle, telescopic tube, tube
extension or suction hose are
blocked.
The filter is dirty.
The results are The bypass vent (Fig. 1/4) is
unsatisfactory in open.
spite of the appli-
The nozzle you are using
ance working cor-
does not suit the flooring.
rectly
The "carpet/hard floor" selec-
tor is in the wrong position for
the particular type of floor.
NOTE:
If you cannot solve the problem following these instructions, contact the Royal Appliance cus-
tomer service page 124, "International Service".
Possible cause
Chapter 3.2, "Switching off and retracting
Solution
Test the vacuum cleaner at another socket which
you are sure carries current.
Have the cord replaced by
tomer Service, address
al Service".
Switch off the vacuum cleaner and pull the plug
from the mains socket. Eliminate the cause of
overheating (e.g. blocked suction channels, fil-
ters, etc.). Wait for about 45 minutes. After the
appliance has cooled off, you may switch it on
again.
Empty/clean the dust container.
Remove the obstacle. If necessary, use a long
wooden stick (e.g. a broomstick) to do this.
Clean the respective filter
ing the dual motor protection filter" or
4.4, "Cleaning the hygienic exhaust filter".
Close the bypass vent (Fig. 1/4).
Select the right brush/nozzle for the type of floor
Chapter 2.3, "Using further nozzles (accesso-
ries)".
Set the "carpet/hard floor" selector to the correct
position for the type of floor,
uum cleaning", step 5.
S C
Cus-
ILVER REST
page 124, "Internation-
Chapter 4.5, "Clean-
Chapter
Chapter 3.1, "Vac-
69
GB
IE
CY