Sonicpoint Leds - SonicWALL SonicPoint Administrator's Manual

SonicPoint LEDs

The SonicPoint has six LEDs:
Power
The SonicPoint G has five LEDs
• Power - The power LED is controlled directly by the 12.0 Volt DC power using power supply
connector (power port) or the 802.3af Power over Ethernet (PoE) through the LAN connector. The
power LED has the following behavior:
SonicPoint State
Power off
Power on, SonicPoint ready
Booting
Reboot to managed or
Standalone Mode
Reboot to Safe Mode
• WLAN 2.4 GHz Radio - The 2.4 GHz Radio LED is controlled by the wireless radio. The LED
blinks at a constant rate when the SonicPoint is ready to receive traffic using the 2.4 GHz radio
(802.11b/g), and blinks at a variable rate when transferring data.
• WLAN 5.0 GHz Radio - (Only appears on the SonicPoint) The 5 GHz Radio LED is controlled by
the wireless radio. The LED blinks at a constant rate when the SonicPoint is ready to receive traffic
using the 5 GHz radio (802.11a), and blinks at a variable rate when transferring data.
• LAN 10/activity - The LAN 10/act LED is controlled by the network interface. It blinks to indicate
10mbit activity.
• LAN Link - The LAN Link LED is controlled by the network interface. It lights to indicate
connectivity.
• LAN 100/activity - The LAN 100/act LED is controlled by the network interface. It blinks to indicate
100mbit activity.
S WALL S P
ONIC ONIC OINT
WLAN 2.4GHz Radio
WLAN 5.0GHz Radio
A ' G
DMINISTRATOR S UIDE
LAN 10/activity
Power LED
off
on, steady
blinking
flash three times (flash is a very short flash of
light--0.25 seconds on and 0.25 seconds off)
Blink three times (blink is a slightly longer
blink--0.5 seconds on and 0.5 seconds off)
SonicPoint Overview
LAN link LAN 100/activity
25