Using The Timer Function; Descaling; Cleaning, Care & Maintenance Of The Appliance - Chicco 06785 Instructions Manual

check the temperature by squeezing a few drops onto the inside of your wrist.
or For baby food jars:
– Stir the contents of the jar to make sure the temperature is even, then taste it to check it is not
ody too hot.
wer NB: If the content is warmed too much, the precious nutrients and vitamins contained in milk may
be destroyed.
he 10. Press and hold the ON/OFF button (d5) for about 3 seconds to switch the bottle warmer OFF.
Disconnect the plug from the mains and the connector from the appliance.

USING THE TIMER FUNCTION

to
en This feature can be used to warm-up the food in advance (up to 1 hour before).
Follow the instructions in steps 1 to 5 of the USER INSTRUCTIONS.
6. Press the Timer button (d4) until you reach the time interval within which the contents should be
ready. Time intervals: 15 min; 30 min; 45 min; 60 min.
7. Press the ON/OFF button (d5) to start the selected cycle.
ac- The led above the button will go red and blink until the actual warm-up cycle begins. The red led
on: will remain fixed from start to finish of the warm-up cycle.
The warming cycle countdown time can be seen on the display (d1).
ut- At the end of this cycle, a visual signal will appear on the display (d1 (00) and the ON/OFF button
out led will turn to green. In addition, the appliance will beep 5 times to indicate the food is ready.
C);
ut- NB: If the time needed to complete the warm-up cycle is longer than the options available for the
nt- Timer function, the numbers will flash on the display (d1) to warn you that the entered time is not
on within the timer threshold. Press the ON/OFF button (d5) to start the selected cycle.
will
WARNING: Always check that the temperature of the food is not too hot before feeding
your child.
We recommend consuming powdered formula mixed with cold water immediately.
NB:
- We recommend consuming warmed milk and baby food immediately.
- Milk and baby food must never be warmed again after feeding. If you warmed the milk/baby food
for a previous meal, throw it away.
CLEANING, CARE & MAINTENANCE OF THE APPLIANCE
When you finish using the appliance, always unplug the bottle warmer's power cord (c) plug from
(a),
the mains socket. Allow the bottle warmer to cool down completely, remove any water left inside
and dry the inside thoroughly; store it in a clean and dry place.

DESCALING

During normal use of the appliance, limescale residue may build up inside the water tank which
nal
can compromise the performance and damage the appliance over time. To remove the limescale
es.
from the bottom of the tank, check that the bottle warmer is cold, make a 200-ml solution of water
and white vinegar, in equal parts, and pour into the tank; leave to soak overnight.
he
Never switch the bottle warmer ON when the tank is being soaked in the water-white vinegar mix.
ure
On completing the descaling cycle, rinse the inside of the tank thoroughly; then wash and dry the
inside and outside of the appliance.
Fill the bottle warmer tank with 140 ml of water and complete an idle warming cycle using the 250
ml feeding bottle fridge starting temperature settings. When the green led above the ON/OFF (d5)
button comes on, switch the appliance OFF, leave to cool down and then remove any water left
en
19