Table of Contents
Advertisement
Inverter / PowerHub
3. Plug in the green 4-pin communication connector to the inverter as
depicted in the diagram below.
4. Locate the main enclosure front cover and bring it in close
proximity of the mounted battery enclosure. Mounting the front
cover is not necessary yet. Wire the small black connector as
referenced earlier coming from the PowerHub, and connect it to
the main enclosure front cover display. Then, place the front cover
back onto the mounted main enclosure and ensure it is secure.
Once the cover is on, tighten the four screws on the front cover,
which will complete this portion installation of the PowerPod 2.
1.
Once the system has been wired, take a photo within the
PowerTools app and press 'Next' to move on to the next step.
68
Installation Manual
Advertisement
Table of Contents
