Pioneer PRA-BD11 Operating Instructions Manual page 9

Note: Be careful, since installation procedures differ for the PRV-LX1 and PRV-LX10.
1. Remove the top panel (PRV-LX1).
÷ Remove the seven screws in the top
panel and the top panel (these
screws will be used to reinstall the
top panel in Step 15).
1. Remove the cover panel (PRV-LX10).
÷ Remove the nineteen screws (seven
in top, four on each side and four on
rear) holding the cover panel, then
remove the cover panel. Save the
screws carefully since they will be
necessary in Step 15 to reinstall the
cover panel.
2. Remove the rear panel blind plate.
÷ To prevent the blind plate from dropping, hold it in place while removing the two
black installation screws (these screws will be used to reinstall the terminal cover in
Step 14).
Remove the blind plate on the
left (as seen from the rear) to
install the PRA-BD11 input board.
Note:
Make sure that the removed
screws are not mixed up with
the screws supplied with this
unit.
Top panel
Remove the blind plate on the
right (as seen from the rear) to
install the PRA-BD12output board.
Installation
Cover panel
Blind plate
PRA-BD11 / PRA-BD12
9
En