Page 1
Anleitung_RG_DP_7525 N_SPK7:_ 10.05.2010 8:25 Uhr Seite 1 Original operating instructions Dirty Water Pump 7525 N Art.-Nr.: 41.706.12 I.-Nr.: 11010 RG-DP...
Page 2
Anleitung_RG_DP_7525 N_SPK7:_ 10.05.2010 8:25 Uhr Seite 2 Read and follow the operating instructions and safety information before using for the first time.
Page 3
Anleitung_RG_DP_7525 N_SPK7:_ 10.05.2010 8:25 Uhr Seite 3...
Page 4
Anleitung_RG_DP_7525 N_SPK7:_ 10.05.2010 8:25 Uhr Seite 4 25 mm (1”) 33,3 mm (1) 38 mm (1 1/2”)
Anleitung_RG_DP_7525 N_SPK7:_ 10.05.2010 8:25 Uhr Seite 5 Strictly avoid pumping aggressive liquids and Important! abrasive substances. When using equipment, a few safety precautions Protect the equipment from frost. must be observed to avoid injuries and damage. Protect the equipment from dry running. Please read the complete operating manual with due Take suitable measures to keep the equipment care.
Anleitung_RG_DP_7525 N_SPK7:_ 10.05.2010 8:25 Uhr Seite 6 4. Proper use 6. Before putting the equipment into operation The equipment you have purchased is designed to pump water with a maximum temperature of 35 °C. 6.1 Installation This equipment must never be used for other liquids, The equipment can be installed either: especially engine fuels, cleaning agents and other Stationary with rigid tubing...
Anleitung_RG_DP_7525 N_SPK7:_ 10.05.2010 8:25 Uhr Seite 7 7. Operation 9. Cleaning, maintenance and ordering of spare parts You can put the equipment into operation after you have thoroughly read the installation and operating Important! instructions. Pay attention to the following points: Unplug the power plug prior to any maintenance Make sure that the equipment is set up securely.
Page 8
Anleitung_RG_DP_7525 N_SPK7:_ 10.05.2010 8:25 Uhr Seite 8 11. Storage Store the equipment and accessories out of children’s reach in a dark and dry place at above freezing temperature. The ideal storage temperature is between 5 and 30 °C. Store the electric tool in its original packaging.
Anleitung_RG_DP_7525 N_SPK7:_ 10.05.2010 8:25 Uhr Seite 9 12. Troubleshooting guide Faults Cause Remedy The equipment does not start - Power supply not connected - Check power supply - Floating switch does trigger - Raise position of floating switch The equipment does not pump - Intake sieve clogged - Clean intake sieve with water jet - Discharge hose kinked...
Page 10
Anleitung_RG_DP_7525 N_SPK7:_ 10.05.2010 8:25 Uhr Seite 10 t For EU countries only Never place any electric tools in your household refuse. To comply with European Directive 2002/96/EC concerning old electric and electronic equipment and its implementation in national laws, old electric tools have to be separated from other waste and disposed of in an environment-friendly fashion, e.g.
Page 11
Anleitung_RG_DP_7525 N_SPK7:_ 10.05.2010 8:25 Uhr Seite 11 The reprinting or reproduction by any other means, in whole or in part, of documentation and papers accompanying products is permitted only with the express consent of ISC GmbH. Technical changes subject to change...
Page 12
Anleitung_RG_DP_7525 N_SPK7:_ 10.05.2010 8:25 Uhr Seite 12...
Page 13
Anleitung_RG_DP_7525 N_SPK7:_ 10.05.2010 8:25 Uhr Seite 13...
Page 14
Anleitung_RG_DP_7525 N_SPK7:_ 10.05.2010 8:25 Uhr Seite 14...
Of course, we are also happy offer a chargeable repair service for any defects which are not covered by the scope of this guarantee or for units which are no longer covered. To take advantage of this service, please send the device to our service address. EINHELL AUSTRALIA PTY LTD 6/166 Wellington Street Collingwood VIC 3066...
Need help?
Do you have a question about the RG-DP 7525 N and is the answer not in the manual?
Questions and answers