Advertisement
SCION
Procedure
Fig. 5-1
1
2
Fig. 5-2
Fig. 5-3
Fig. 5-4
Issue: A
04/15/04
tC
2005 -
3
Page 6 of 17 pages
VSE SUBWOOFER (BAZOOKA
5. Routing Wire Harness
(a) Starting at the rear of the vehicle, route the pig
tail end underneath the rear strut
reinforcement access panel, and route towards
rear passenger side taillight. (Fig.5-1)
(b) Using the 12mm socket, remove the #3 Child
Restraint bracket bolt, & re-install groud ring
underneath bracket. (Fig.5-2)
(1) Torque bolt to 15 lbf·ft
(c) Run the T-Harness portion of the W/H
forward between the passenger seat bracket
and inner wheel well. (Fig.5-3)
(d) From inside the back seat, route W/H behind
seat belt & tuck under the rear passenger
speaker / cup holder panel.
(e) Using a NRT, remove the panel-fastening clip.
(Fig.5-4)
(1) Proceed to route the wire harness
underneath clip tab, and back underneath
panel, with the T-Harness portion of the
wire harness exiting at the passenger side
entry way.
(f) Route wire harness forward through existing
vehicle-accommodated clips.
®
)
Advertisement
