Advertisement
SCION
Procedure
Issue: A
04/15/04
tC
2005 -
Page 12 of 17 pages
VSE SUBWOOFER (BAZOOKA
12. Resetting Vehicle Components
(a) Reset the power windows.
(1) Turn ignition key to ON position.
(2) Push down the power window switches of
each door, and lower the windows
halfway.
(3) Pull up the switches until the windows
close and hold switches up for a further
one (1) second (minimum.)
(b) Reset the power moon roof.
(1) Push and hold moon roof switch to close
side until moon roof closes. Hold for a
further two (2) seconds.
13. Test and Set Up Procedures
(a) If system is installed correctly, the VSE
Subwoofer will power up when the vehicle's
ignition is turned on. (This can be confirmed
by the lighting of the POWER L.E.D. on the
Gain Control module of the unit.) (Fig.9-5)
(b) Using the tone controls on the radio, adjust the
balance left and right, to verify that VSE
Subwoofer produces sound on both sides, and
that the sound is loudest when the balance is
set to the center.
(c) Tune to a radio station or CD, and adjust
volume to a comfortable listening level. (If
the sound is distorted, adjust the gain control
knob counter-clockwise (-) until the VSE
Subwoofer produces clean sound. If the unit
cannot be heard, adjust the gain control
clockwise (+) until sufficient output is
achieved.)
(d) Carefully reinstall grille.
®
)
Advertisement
