Advertisement
Quick Links
TOYOTA
TUNDRA D-CAB
Preparation
Part Number: PTS20-34040 (VSE)
PTS20-34042 (JBL Wire Harness)
VSE Kit Contents
Item #
Quantity Reqd.
1
1
4
1
5
1
Wire Harness Bag Contents
Item #
Quantity Reqd.
1
1
2
1
3
4
4
2
5
1
Additional Items Required For Installation
Item #
Quantity Reqd.
1
Conflicts
None:
Recommended Tools
Personal & Vehicle
Protection
Vehicle Protection
Part Protection
Special Tools
Installation Tools
Panel Removal Tool
Socket/Ratchet
Socket Extension
Torque Wrench
Pliers
Screwdriver (Manual or
Electric)
Clip Removal Tool
Special Chemicals
Cleaner
Issue: A
12/22/04
Description
Vehicle Specific Enclosure
(VSE) Subwoofer
Product Feature Placard
Service Care Card
Description
JBL Audio VSE Wire
Harness
Instruction sheet
7" Wire Ties
Foam Tape
10mm Ground Bolt
Description
Notes
Seat/Floor Covers
Blankets
Notes
Notes
Nylon Removal Tool (NRT)
10mm
6 inch (optional)
3 lbf·ft , and 10 lbf·ft
1. Diagonal Cutters
2. Long Nose (optional)
Magnetized Philips # 2
Notes
TM
3M
Prep Solvent–70 (if
required)
Page 1 of 11 pages
2004 -
NOTE: Part number of this accessory may not be
the same as the part number shown.
General Applicability
All Tundra D-Cab Grades w/JBL AUDIO
Recommended Sequence of Application
Item #
Accessory
1a
Install Security/Audio
1b
Install VSE Subwoofer
2
Install Molded Dash
Vehicle Service Parts
Item #
Quantity Reqd.
1
Legend
STOP: Damage to the vehicle may occur. Do not
proceed until process has been complied with.
OPERATOR SAFETY: Use caution to avoid risk of
injury.
CAUTION: A process that must be carefully observed
in order to reduce the risk of damage to the
accessory/vehicle and to ensure a quality installation.
TOOLS & EQUIPMENT: Used in Figures calls out t
specific tools and equipment recommended for this
process.
REVISION MARK: This mark highlights a change in
installation with respect to previous issue.
Bass Tube Specifications
Woofer Size
Voice Coil Size
Magnet Size
Frequency Response
Efficiency
Power Handling
Dimensions
Weight
Impedance
VSE SUBWOOFER (JBL)
*Mandatory
(may be required for reassembly)
Description
6"
1"high power/high
temp.
15 oz.
39 – 85 hz.
105dB
100 watts
18.125" x 8.5" x 10"
14 lbs.
2 ohms DVC
he
Advertisement
Related Manuals for Bazooka PTS20-34040
Summary of Contents for Bazooka PTS20-34040
- Page 1 TOYOTA TUNDRA D-CAB Preparation Part Number: PTS20-34040 (VSE) PTS20-34042 (JBL Wire Harness) VSE Kit Contents Item # Quantity Reqd. Description Vehicle Specific Enclosure (VSE) Subwoofer Product Feature Placard Service Care Card Wire Harness Bag Contents Item # Quantity Reqd. Description...
-
Page 2: Pre-Installation Precautions
TOYOTA TUNDRA D-CAB Procedure Care must be taken when installing this accessory to ensure damage does not occur to the vehicle. The installation of this accessory should follow approved guidelines to ensure a quality installation. These guidelines can be found in the "Accessory Installation Practices" document. This document covers such items as:- •... - Page 3 TOYOTA TUNDRA D-CAB Procedure Fig. 7e Fig. 7f Fig. 7g Fig. 8b Fig. 8a Fig. 8d Fig. 8c Fig. 8e Issue: A 12/22/04 2004 - VSE SUBWOOFER (JBL) (4) Unsnap the cab panel from the cab and remove from vehicle. (5) There are a total of 17 clips attached to the panel, in the event that any clips remained attached to the vehicle, remove...
- Page 4 TOYOTA TUNDRA D-CAB Procedure Fig. 8f Fig. 8g Fig. 8h Fig. 8i Keep clear for panel clip Wire tie to bracket Issue: A 12/22/04 2004 - (g) Route wire harness along the factory harness and wire tie as shown. (Fig. 8f & 8g) (1) Start the wire tie outside the pillar cover and slide up the harness, tighten to the Harness...
- Page 5 TOYOTA TUNDRA D-CAB Procedure Torque Wrench, 10mm Socket Negative Battery Cable Fig. 10-1 Fig. 11a Issue: A 12/22/04 2004 - (d) Reconnect the negative battery terminal. 90˚ (e) Turn ignition key to "ACC" position. (f) Press the power button on the receiver/player (g) Verify that the green led on the VSE is NOTE: If the green light on the VSE unit is illuminated, and there is no sound coming from...
- Page 6 TOYOTA TUNDRA D-CAB Procedure Issue: A 12/22/04 2004 - VSE SUBWOOFER (JBL) (c) Using the tone controls on the radio, adjust the balance left and right, to verify that VSE Subwoofer produces sound on both sides, and that the sound is loudest when the balance is set to the center.
- Page 7 CD player functions & Satellite Tuner stations are playing (if equipped) Reception of AM/FM stations Bazooka Tube – Listen to Bazooka Tube to make sure it is functioning properly or by feeling the Bazooka for vibration. Be sure the Phase Switch is in the “UP” position.
- Page 8 TOYOTA TUNDRA D-CAB Troubleshooting Condition: No sound from VSE Subwoofer, however factory speakers still play Distorted Sound Low Sound Rattling Noises Issue: A 12/22/04 2004 - VSE SUBWOOFER (JBL) Check For: o Is the green L.E.D. lit on the VSE Subwoofer? If not, check for 12 volts on pins of the VSE Subwoofer with the ignition on.
- Page 9 TOYOTA TUNDRA D-CAB Troubleshooting Condition: Dimming Radio Lights Radio does not come on No Sound at all VSE Subwoofer produces sound on the right or the left, but not both. Issue: A 12/22/04 2004 - VSE SUBWOOFER (JBL) Check For: o Dimming Radio Lights could occur when the VSE Subwoofer is played at high volumes.
- Page 10 TOYOTA TUNDRA D-CAB Wire Harness & Radio Wiring Schematics Amplifier POWER Connector Pin No. Pin No. NA* indicates No connection made to this wire. Issue: A 12/22/04 2004 - WIRING CONNECTOR SCHEMATICS: Amplifier DATA Connector Amplifier POWER Connector Wire Color Right Rear Negative Speaker Wire Right Rear Positive Speaker Wire Dimmer...
-
Page 11: Wire Color
TOYOTA TUNDRA D-CAB Wire Harness & Radio Wiring Schematics Pin No. NA* indicates No connection made to this wire. Issue: A 12/22/04 2004 - Subwoofer Connector Wire Color Black Chassis Ground White Left Front Speaker (+) Grey Right Front Speaker (+) 12 Volt Battery Connection (B+) Blue/White Remote Turn-On/Ignition (Switched+)