Advertisement
TOYOTA
Procedure
Torque Wrench, 10mm Socket
Negative Battery Cable
Fig. 10-1
Fig. 11a
Issue: A 12/22/04
TUNDRA D-CAB
90˚
LED
Fig. 11b
2004 -
(d) Reconnect the negative battery terminal.
(Fig. 9a)
(1) Position the negative terminal at an angle
of 90˚ to the battery as shown.
(2) Tighten the nut with 4.1 N-m (36 lbf-in)
of torque.
(3) Be careful not to touch the positive
battery terminal.
(e) Turn ignition key to "ACC" position.
(f) Press the power button on the receiver/player
head unit. Verify the backlighting
illuminates.
(g) Verify that the green led on the VSE is
illuminated, and that sound is coming out of
the driver.
NOTE: If the green light on the VSE unit is
illuminated, and there is no sound coming from
the driver –then one (or more) of the four (4)
speaker wires are disconnected.
NOTE: If the green light on the VSE unit is
NOT illuminated – then the wire harness is not
properly connected to either the radio/amplifier,
or is not properly grounded.
7. Reassemble Interior
8. Test and Set Up Procedures
(a) Verify Gain Control Adjustment
(1) If necessary, match up white mark on
gain control knob with mark on
enclosure. (Figs.11a & 11b)
(b) If system is installed correctly, the VSE
Subwoofer will power up when the vehicle's
ignition is turned on. (indicated by
illumination of the POWER L.E.D. on the
Gain Control module of the unit.)
Page 5 of 11 pages
VSE SUBWOOFER (JBL)
Advertisement
