Advertisement
TOYOTA
Procedure
Care must be taken when installing this accessory to ensure damage does not occur to the vehicle. The installation of this
accessory should follow approved guidelines to ensure a quality installation.
These guidelines can be found in the "Accessory Installation Practices" document.
This document covers such items as:-
•
Vehicle Protection (use of covers and blankets, cleaning chemicals, etc.).
•
Safety (eye protection, rechecking torque procedure, etc.).
•
Vehicle Disassembly/Reassembly (panel removal, part storage, etc.).
•
Electrical Component Disassembly/Reassembly (battery disconnection, connector removal, etc.).
Please see your Toyota dealer for a copy of this document.
Fig. 2a
Fig. 7a
Fig. 7c
Issue: A 12/22/04
TUNDRA D-CAB
Negative Battery Cable
10 mm Socket
Fig. 7b
Fig. 7d
2004 -
1. Pre-installation Precautions
(a) Use Seat & Floor Protectors and Fender
STOP
Covers/Blankets to avoid damage to surfaces.
Operator Safety Warning (if applicable.)
(b) Place all removed parts on a protective
STOP
surface.
2. Battery Disconnect
(a) Remove the NEGATIVE (-) battery terminal
using a 10mm socket before any disassembly
starts. (Fig. 2a).
3. Disassemble Driver Rear Scuff Plate
(a) Remove driver side rear scuff plates by
removing the 3 Phillips screws and carefully
pulling upward. (Fig. 6c)
4. Remove Rear Cab Panel
(a) Slide the front seats forward.
(b) Tumble both the passenger and drivers' rear
seats forward.
(c) Remove the rear cab panel
(1) Release the 2 cargo hangers by pulling on
the head of the hanger. (Fig. 7a & 7b)
(2) Using an NRT, remove the bolt cover.
(Fig. 7c)
(3) Using a 10mm socket, remove the 10mm
bolt that attaches the cab panel. (Fig. 7d)
Page 2 of 11 pages
VSE SUBWOOFER (JBL)
Advertisement
