About Bluetooth Icons; Connection; Connecting A Cellular Phone - Sony MEX-BT5700U Operating Instructions Manual

Notes
• While connecting to a Bluetooth device, this unit
cannot be detected from another device. To enable
detection, disconnect the current connection and
search for this unit from another device.
• Depending on the device, searching from this unit
may not be possible. In this case, search for this unit
from the connecting device.
• If you search for this unit and the connecting device
mutually at the same time, this unit will not recognize
the connecting device.
• It may take time to search or connect.
• Depending on the device, the confirmation display of
the connection appears before inputting the
passcode.
• The time limit for inputting the passcode differs
depending on the device.
• This unit cannot be connected to a device that
supports only HSP (Head Set Profile).

About Bluetooth icons

The following icons are used by this unit.
lit:
off:
lit:
flashing:
off:
lit:
flashing:
off:
* Turns gray without handsfree connection. Differs in
the case of a cellular phone.
24
Bluetooth signal on
Bluetooth signal off
Connection successful
Connecting
No connection
Connection successful
Connecting
No connection
Signal strength indication
of the connecting cellular
phone*
Battery remaining of the
connecting cellular phone*

Connection

If pairing has already been achieved, start
operation from here.

Connecting a cellular phone

1
Be sure that both this unit and the
cellular phone are switched to
Bluetooth signal on.
2
Connect to this unit using the cellular
phone.
" "appears when the connection is made.
Connecting to registered devices
1
Press (BT).
The Bluetooth settings menu appears.
2
Rotate the control dial to select
"Device List," then press the select
button.
The list of registered devices appears.
3
Select the device to connect.
4
Select "Handsfree Connect."
"Connection Complete" appears and
connection is complete.
" " appears during connection.
To stop the connection
Select "Handsfree Disconnect" in step 4.
Deleting the registration of a
connected device
Select "Delete" in step 4.
Note
While streaming Bluetooth audio, connection noise
may be heard over playback sound.
Tip
With Bluetooth signal on: when the ignition is switched
to on, this unit reconnects automatically to the last-
connected cellular phone. But automatic connection
also depends on the cellular phone's specification. If
this unit does not reconnect automatically, connect
manually.